Half Face Gas Mask Facepiece Chemical Spray Painting Safety 6200 Respirator

Description

17in1 Half Face Gas Mask Facepiece Chemical Spray Painting Safety 6200 Respirator
Specifications:
Type: Gas Mask
Material: Silicone + Activated Carbon
Features:
1.Half Face:Convenient design provides a good overview, and compatibility with eye protection and head.
2.Adjustable:The fastening system of two elastic rubber straps on the cotton and the headband is regulated at four points.
Package Includes:
1 x 6200 Gas Mask
2 x 6001 Filter Cartridge
12 x 5N11CN Cotton Filter
2 x 501 Filter Cotton Cap
Instructions for use:
1.Hold the end of the strap with both hands, pull the strap all the way, so that the mask can completely cover the nose and mouth area, and connect the fastener behind the neck to seal the mask and the face.
2.Pull the end of the strap again to further tighten it.
3. Before use, check the mask to determine whether it is properly sealed, cover the air inlet side of the filter box with your palm, gently inhale, and hold for 5-10 seconds. If the mask is a little recessed, it proves that the effect is good. If tested The air leaks in the middle, adjust the tightness of the mask and re-adjust the elastic belt, eliminate the leakage, and re-do the airtight inspection until it is qualified.
4.During use, when the user smells the smell or the inhalation resistance increases, the service life of the cartridge has expired, please replace the cartridge or cotton filter immediately.
Special NOTE for users
1. Please do not use this mask when the oxygen concentration is lower than 18%.
2. Please do not use in the following situations:
(1) Unknown hazardous substances
(2) The concentration of harmful substances reaches a concentration that immediately endangers life and health
(3) When you smell or taste harmful substances.
3. Don't modify this mask
4. Before use, a qualified person should conduct pre-use training.
5. When not in use, store the mask in a place away from contaminants and keep it sealed